Energy Performance Indicator

Energy Performance Ratings for Windows, Doors, and SkylightsHouse/Compass

You can use the energy performance ratings of windows, doors, and skylights to tell you their potential for gaining and losing heat, as well as transmitting sunlight into your home.

Heat Gain and Loss

Windows, doors, skylights can gain and lose heat in the following ways:

* Direct conduction through the glass or glazing, frame, and/or door

* The radiation of heat into a house (typically from the sun) and out of a house from room-temperature objects, such as people, furniture, and interior walls

* Air leakage through and around them.

These properties can be measured and rated according to the following energy performance characteristics:

U-factor The rate at which a window, door, or skylight conducts non-solar heat flow. It’s usually expressed in units of Btu/hr-ft2-ºF. For windows, skylights, and glass doors, a U-factor may refer to just the glass or glazing alone. But National Fenestration Rating Council U-factor ratings represent the entire window performance, including frame and spacer material. The lower the U-factor, the more energy-efficient the window, door, or skylight.

Solar heat gain coefficient (SHGC) A fraction of solar radiation admitted through a window, door, or skylight—either transmitted directly and/or absorbed, and subsequently released as heat inside a home. The lower the SHGC, the less solar heat it transmits and the greater its shading ability. A product with a high SHGC rating is more effective at collecting solar heat gain during the winter. A product with a low SHGC rating is more effective at reducing cooling loads during the summer by blocking heat gained from the sun. Therefore, what SHGC you need for a window, door, or skylight should be determined by such factors as your climate, orientation, and external shading. For more information about SHGC and windows, see passive solar window design.

Air leakage The rate of air infiltration around a window, door, or skylight in the presence of a specific pressure difference across it. It’s expressed in units of cubic feet per minute per square foot of frame area (cfm/ft2). A product with a low air leakage rating is tighter than one with a high air leakage rating.

Sunlight Transmittance

A window’s, door’s, or skylight’s ability to transmit sunlight into a home can be measured and rated according to the following energy performance characteristics:

Visible transmittance (VT) A fraction of the visible spectrum of sunlight (380 to 720 nanometers), weighted by the sensitivity of the human eye, that is transmitted through a window’s, door’s, or skylight’s glazing. A product with a higher VT transmits more visible light. VT is expressed as a number between 0 and 1. The VT you need for a window, door, or skylight should be determined by your home’s daylighting requirements and/or whether you need to reduce interior glare in a space.

Light-to-solar gain (LSG) The ratio between the SHGC and VT. It provides a gauge of the relative efficiency of different glass or glazing types in transmitting daylight while blocking heat gains. The higher the number, the more light transmitted without adding excessive amounts of heat. This energy performance rating isn’t always provided.

For more information on how  Energy Performance Ratings for Windows, Doors and Skylights will affect the energy efficiency of your house, or you would like to know more about the service Sustainability WA provide including an Energy Rating or Energy Efficiency certification for your project please contact us here or phone 08 9537 2000

Other terms sometimes used to describe an energy rating includes:  Energy Star, Energy Audit, Energy Ratings, Energy Efficiency Certificate, Energy Assessment, HERS, BER or EPC.

Sustainability WA can help you with them all!

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>